|
MATERIAL SAFETY DATA SHEET
| Product Name: |
ACRYLIC PLASTIC SEALER & CRACK FILLER |
| Product Use: |
Protective Coating |
| Common Name: |
Aqueous Asphalt/Acrylic Coating |
|
|
|
SECTION I: Manufacturer Information
| Manufacturer Name: |
Metacrylics |
| Address: |
142 N. 27th Street
San Jose, CA 95116 |
| Emergency: |
(408) 280-7733 Mon - Fri / 9am - 4pm
(408) 280-6329 Fax |
|
|
|
SECTION II: Hazardous Ingredients/Identity Information
| Ingredient(s) |
WT.% |
CAS # |
Exposure Limits in Air |
| ACGIH (TLV) |
OSHA |
Other |
| Acrylic Resin |
10-12 |
N/A |
None |
None |
None |
| Ammonia |
0.1 |
7664417 |
25 ppm
(TWA) |
50 ppm |
50 ppm
NIOSH (REL) |
| Asphalt |
45 - 5 |
08052424 |
5 mg/m3
(TWA) |
None |
5 mg/m3
(TWA) |
| Hydroxyethylcellulose |
.5 - .6 |
9004-62-0 |
None |
None |
None |
| Sodium Hydroxide |
.5 - .7 |
1310732 |
2 mg/m3
(Ceiling) |
2 mg/m3
(Ceiling) |
250 mg/m3
(NIOSH IDLH) |
|
|
|
|
SECTION III: Physical/Chemical Characteristics
| Boiling Point: |
100 C |
Specific Gravity: |
1.05 - 1.15 |
| Vapor Pressure: |
15.0 at 20 C |
Melting Point: |
N/A |
| Vapor Density: |
<1,Water |
Evaporation Rate: |
Equals Water |
| Solubility in Water: |
Miscible |
Boiling Point: |
100 C |
| Odor And Appearance: |
Black viscous liquid, mild ammonia odor |
|
|
|
SECTION IV: Fire and Explosion Hazard Data
| Flammability: |
Non-flammable |
| Autoignition Temp: |
N/A |
UEL (% vol): |
N/A |
| Flash Point: |
N/A |
LEL (% vol): |
N/A |
| Extinguishing Media: |
Carbon Dioxide, Dry Chemical or Foam |
Special Fire Fighting
Procedures: |
None |
Unusual Fire & Explosion
Hazards: |
Material can splatter above 100 C, dry polymer can burn. |
Hazardous Combustion
Products: |
May generate carbon dioxide, monoxide, hydrogen sulfide |
|
|
|
SECTION V: Reactivity Data
| Stability: |
Stable |
Hazardous Decomposition: |
None |
| Incompatibility: |
N/A |
Hazardous Polymerization: |
Will not occur |
| Oxidizer: |
No |
Reactivity: |
None |
| Conditions to Avoid: |
N/A |
|
|
|
SECTION VI: Health Hazard Data
| Skin Contact: |
Repeated exposure and washing may irritate the skin. Asphalt fume condensateshave been shown to produce a tumorogenic response when repeatedly applied to the skin of experimental animals. The relevance of this data to humans is not known at this time. |
| Eye Contact: |
Liquid, mists and vapors can irritate the eyes. |
| Inhalation: |
Mists and vapors developed during spray application may cause upper respiratory irritation. (see Other effects) |
| Ingestion: |
May cause dizziness, nausea and abdominal pains. |
| Carcinogenicity: |
Not considered a carcinogen by IARC, NTP or OSHA. |
| Other: |
Breathing asphalt aerosol or asphalt smoke for protracted periods of time has produced damage to the lungs in mice. Among the changes observed were bronchitis, and abscess formation. |
|
|
|
FIRST AID PROCEDURES:
| Skin Contact: |
Wash skin thoroughly with a mild soap and water. Consult a doctor if irritation develops. |
| Eye Contact: |
Flush eyes fully with clean water. Consult doctor if irritation develops. |
| Inhalation: |
Remove to fresh air. Apply artificial respiration if patient is not breathing. Get immediate medical attention. |
| Ingestion: |
If conscious, give victim 2 glasses of clean water and induce vomiting by placing a spoon or finger at the back of the throat. Do not give anything to an unconscious or convulsing person. Get immediate medical attention. |
|
|
|
SECTION VII: Precautions for Safe Handling and Use
In Case of
Spill or Leak: |
Keep spectators away. Floor may be slippery. Contain spill with inert material or absorbent. Do not allow to enter drain or waterways. Transfer liquid material to containers for recovery or disposal and solid containment material to separate containers for disposal. |
| Disposal: |
Absorb materials with an inert absorbent material and place in sealable containers. Landfill the solids and contaminated containment materials according to local, state and federal regulations. |
| Note: |
Dispose of contaminated product and materials used for clean-up in a manner approved by local, state or federal laws and regulations. |
|
|
|
SECTION VIII: Control Measures
| Ventilation: |
General ventilation is normally adequate. |
| Respiratory: |
If use conditions create vapors or mists, or limited ventilation is available, a NIOSH approved organic vapor mask with a dust/mist pre-filter is recommended. |
| Clothing: |
Long sleeved cover-alls, rubber gloves and safety shoes are recommended. |
| Eyes: |
Goggles are recommended for spray application. |
| Other: |
Wash hands and face thoroughly before eating or handling food. |
|
|
|
PREPARATION OF MATERIAL SAFETY DATA SHEET:
| Prepared By: |
Instant Asphalt, Inc. |
| Date: |
April
6, 2004 |
|
